Many netizens are worrying that the washbasin in the bathroom is a good one for buying a suit or a sink for oneself. Which kind of benefit is more? Today Xiao Bian took everyone to see how to use cement to build a washbasin cabinet.
Because it is a cast-in-place basin, it must be reinforced and reinforced. This is similar to the use of reinforced concrete in a building, which can make the building more firm. There are also cement boards on the market, but the quality is quite different. As in some Mediterranean styles, the building of TV cabinets, etc., often involves the step of placing reinforcements. The workers here are reinforcing steel bars in a good measure.
Then the loft was laid out, the bricks were put out of the basin mold, and the steel bar was pressed up, and a cement bag could be put underneath.
Pour the mixed bean mortar into the mold you just made and level it with a shovel. This process must be completed and there must be no empty drums inside. Shake the cement bag and make the mortar more uniform.
Formal basins were erected, and all hanging places had angled steel supports.
Has begun to take shape.
Open the hole in the cement board according to the size of the wash basin, one side is the angle steel brushed with anti-rust paint, it is specially prepared for the tap. Since the slab is nearly 5cm thick and the tiles are at least 2cm thick, the sum is much larger than the length of the thread of a common faucet. The thickness of the angle steel is 0.6cm, and the tile is 2cm, a total of 2.6cm, so that the screw mouth is sufficient However, the angle steel should be wide enough to allow the entire hand to enter the fixed thread.
Then tile the tile, which is similar to the wall tile, in the corner of the place can be inverted 45 degrees, this is more beautiful. Paving can be pre-paved before, and the faucet should be left on the countertop.
You have done your job. After the faucet has been installed, the entire washbasin is ready.
>>> Links: The whole process of making cement cabinets and lessons learned
Construction Acceptance Tiles Three Trees Paint Cement Faucet Lacquer Cabinet Doors Bathroom Doors Size Bathroom Tiles Bathrooms Washbasins Bathroom Doors Bathroom Size
The transmission range of Zinc Selenide ZnSe-CVD is 0.5 - 20 µm.
ZnSe CVD used for high power CO2 laser optics at 10.6µm, for protective optics windows or optical elements in FLIR (forward looking infrared) thermal imaging equipment, optics for medical and industrial applications (optical plane parallel windows (plates, disks, blanks), wedged windows, optical meniscus, spherical and cylindrical lenses, prisms, resonator mirrors of CO2 laser).
The refractive index is near 2.4. Zinc Selenide has a very low absorbtion coefficient and is used extensively for high power infrared laser optic. It is non-hygroscopic.
Zinc Selenide (ZnSe) - transparent in wide spectral range from yellow (visible) to far IR. ZnSe material is a chemically inert, non-hygroscopic and highly pure product that is very effective in many optical applications due to its extremely low bulk losses, high resistance to thermal shock and stability in virtually all environments, easily machined.
Special care should be taken when handling Zinc Selenide as it is a toxic material. Always wear rubber or plastic gloves to avoid risk of contamination.
Zinc Selenide Co2 Laser Lens,Zinc Selenide Focusing Lens,25.4Mm Znse Lens,Zinc Selenide Lens
China Star Optics Technology Co.,Ltd. , https://www.opticsrealpoo.com